
The Visual_Guide, Screen_Holder and Lens_Slides
As these incorporate screw threads and sliding components, you need to print with these settings:
- NO SUPPORTS
- 95% Infill
- 2 perimiter walls
- 4 Top Layers, 4 bottom layers
There is actually very few “thick” areas, so they are very lightweight. A layer height of 0.2 or 0.24 is fine for these
The Main Body
As long as you print this with 2 perimiter walls, you can drop the infill down to 5% – & you will still find that they are rock solid. Again, they are designed specifically to print with NO SUPPORTS. Because they are almost completely hidden by the Outer_Shell, you can easily print these with a layer height of 0.24 or 0.28, and I would definitely not advise any lower than 0.2
- NO SUPPORTS
- 5% Infill
- 2 perimiter walls
- 4 Top Layers, 4 bottom layers


The Outer Shell
The Outer Shell is basically a twin wall shell with a four layer lip at the bottom. As it has nothing that could ever be described as “thick”, you can print it with these settings:
- NO SUPPORTS
- 95% Infill
- 2 perimiter walls
- 4 Top Layers, 4 bottom layers
Again, a layer height of 0.2 works beautifully for this, although even with 0.24 and 0.28 it’s hard to tell the difference.
The Fasteners
The Main Body is clipped together with eight round pegs and two triangular bars. These are not load bearing and as such can also very happily be printed with our 5% infill, twin perimiter wall and four top/bottom layers.
